Seite 1 von 1

pen pressure surface pro 3

Verfasst: So Sep 07, 2014 10:29 pm
von philippecmartin
Hi,

Setting the brush size parameter on my sp3 does not seem to have any impact as the size stays even (purchased version of aw)

Any advice?

Regards,

Philippe

Re: pen pressure surface pro 3

Verfasst: Mo Sep 08, 2014 3:32 am
von philippecmartin
ps:fairly sure the ntrig driver follows a different protocol than wintab.

Re: pen pressure surface pro 3

Verfasst: Di Sep 09, 2014 1:05 pm
von Boris Eyrich
Artweaver needs Wintab to use pen pressure but there should be also a Wintab driver available for the surface pro 3.

Please check the ntrig driver page for it: http://www.ntrig.com/Content.aspx?Page=Downloads_Drivers

Re: pen pressure surface pro 3

Verfasst: Mi Sep 10, 2014 5:31 am
von philippecmartin
Hi,

Thanks but I have that installed already - got it tested with Artrage so I'm fairly certain it works.

What else could it be ?


Regards,

Philippe